JET DRYER HEPA FILTER FOR HAND DRYER SLIM Package contents: 1 piece

HEPA Filter is designed for the Jet Dryer SLIM hand dryer.

The certified HEPA filter is used to capture even the smallest dust particles.

The SLIM hand dryer uses 2 pieces of HEPA filters for its operation!

Removing HEPA filters

Extend the drip tray. Remove the front cover of the dryer. Place your hand under the cover and pull horizontally until the cover loosens at the bottom. Then push upwards and the cover will fully release.

In case of anti-vandal securing of the front cover, it is necessary to remove the entire hand dryer from the wall and unlock the front cover with two screws on the back side of the hand dryer. Then the cover can be snapped out.

You will find the air filters on the sides of the front cover. Unscrew the securing screws and remove the filters.

Cleaning HEPA filter

Remove dirt with a gentle tap or use a vacuum cleaner, you can also use a soft brush. If the HEPA filter is heavily contaminated, it needs to be replaced. Filters are recommended to be cleaned every 2 months.

!!! Do not rinse the filters with water !!!

Insertion of HEPA filter

Insert the filters back into the plug-in slots, secure the screws and securing clips. Attention! If not inserted correctly, dirt or dust may enter the functional parts and the lifespan of the device may be shortened.

1. Put the front cover into the locking grooves on the top part of the dryer.

2. After ensuring that the upper part of the cover is in the locking grooves, push the bottom part of the cover towards the dryer until you hear a click. Check if the cover is properly fitted.

In case of using an anti-vandal system, it is necessary to secure the front cover with two screws on the rear part of the hand dryer.

Note: package contains 1 piece of HEPA filter